Sensormatic VM96 INS Manuel de l'opérateur télécharger pdf (Page 102)

6-8 View Manager 96 Operator's Manual

On the TOUCH TRACKER, press Clear Entry to return to the Utility Mode

prompt. Press

Clear Entry again to return the TOUCH TRACKER to normal

camera control.

Resetting the TOUCH TRACKER

If TOUCH TRACKER commands are not working properly, or the system is

not operating as expected, try resetting the T

OUCH TRACKER. Before you

reset a T

OUCH TRACKER, however, have your System Administrator run a

diagnostic test on that T

OUCH TRACKER. This test is called a network ping.

This test is accessed through the Administrator's Menu Utilities Network

Maintenance function. The network ping test enables you to isolate the

OUCH TRACKER and determine if it is causing the problem.

If the System Administrator determines that the T

OUCH TRACKER has a

problem, you can reset that T

OUCH TRACKER.

1. At the Utility Mode prompt, press

The LCD displays the following prompt:

2. To reset the T

OUCH TRACKER, press 0; to exit without resetting, press

Clear Entry.

The Utility Menu disappears from the screen, the T

OUCH TRACKER beeps

and its lights momentarily go out.

When the T

OUCH TRACKER comes back up, the “Enter Password?” prompt

is displayed on the LCD (if passwords are enabled). If passwords are not

enabled, the monitor and camera numbers are blank, and the T

OUCH

TRACKER address is displayed on the LCD. Remember to select a monitor

before you begin VM96 operation again.

Press 0 to Reset

Other keys exit

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 121 122

Pas de commentaire

Sensormatic VM96 INS Manuel de l'opérateur Page 102